âś…
Setup Complete
This device has registered with the hub and will reboot into kiosk mode in 5 seconds.
Heads up: system clock is not yet NTP-synced. If the kiosk shows TLS errors after boot, wait 1-2 minutes for time sync to complete.
What happens next?
- Device reboots automatically.
- Kiosk service starts and loads assigned dashboards from the hub.
- Device appears as online in the portal within 2-5 minutes.
- If kiosk content does not appear, check the Portal Device Dashboard and run Run Self-Diagnostic.
📶
LTIT-Setup-…
Password: —
🔌
Wired Connection Detected
Interface: eth0 · IP: —
Skip WiFi setup and continue using the wired network.
You can switch to WiFi later by physically holding the top-right corner of the screen for 10 seconds, or from the admin portal.
Select WiFi Network
Scanning…
-
🔍
Scanning for networks…